Everyone who decided to buy a used car faces the question: where to start, what is needed to buy a car and how to check its technical condition. First of all, decide on the following things:
- You need to know the exact amount for which you want to buy a car.
- Above this, you need to have about 10% of the planned cost of the machine. These funds will need to be spent, after purchase, for registration of purchase and sale, registration, insurance, inspection, other payments, as well as fine-tuning and repair.
- The amount of time spent searching, oddly enough, is proportional to the state found and selected in the end.
- As with any test and exam, you need to prepare for the purchase. To do this, you must read and, if possible, remember the main advantages and disadvantages of the car that you are going to buy.
Car Check Algorithm
The following is a clear car check algorithm that will reduce the chance of making the right choice when buying and avoid the cost of diagnostics. You can use this instruction directly at the site of the vehicle inspection. In addition, it implies that you have a certain experience in car maintenance. Specially with the used cars Sidcup this will go perfectly now.
Checking the body
Checking the body should pay attention to the following points. The car must be clean, otherwise the inspection of the body loses its meaning. Sit down near the right headlight of the car and carefully inspect the right side of the car – whether there are dents, defects in geometry and color. Repeat this procedure at the left side, and then similarly inspect the hood and roof. From this angle, almost all the “fixed” places are visible. It is advisable to conduct a similar inspection from the trunk.
If it falls off then there is putty
Carefully inspect the joints (between the hood and the wings, racks and doors, etc.) this is a good indicator of the emergency past of the car. The normal joint has the same width along the entire length. Pay attention to the stickers and inscriptions – this is usually a “masking” of defects. Check all the doors they should close with one effort and sound. Otherwise – the body geometry is broken.
If you have doubts about the correctness of the geometry of the body, then accurate information will only check on control points on a special stand. You can limit yourself to a simple check of the diagonals, for which you need to hang the car and use a piece of twine.